|
The working procedures of concrete pump
|
|
Post Reply
|
 Posted 04:14 AM Friday, August 7, 2015 [
quote ]
Procedures of Concrete pump
1, the storage tank should be filled with water, when water turbidity and when there are more sand, timely check processing. 2, pumping mobile concrete mixer for sale, not open to any pipeline and hydraulic pipes; shall adjust, repair parts are functioning. 3, operation, pumping equipment and piping to respond to observe, discover hidden promptly. Tube wear than prescribed, clamps, seals, etc. should be replaced. 4 concrete batching plant specification, should prevent pipe blockage. Stir well pumping concrete, control slump; during pumping, the pump must not stop halfway. 5, when there is clogging pipes, they should be anti-pump operation, the return of the concrete hopper; several times when the pump still does not eliminate the anti-clogging pumps should be unloaded in the case, removed the tube to exclude blockage. 6, after the operation, should be within the hopper and concrete pipes all output, then pumps, hoppers, pipelines, etc. rinse. When flushing pipes with compressed air, the intake valve should immediately open a large, smooth discharge only when the concrete before the intake valve open to the maximum. In front of the outlet end of the pipe 10m forbidden to stand, such as the collection and application of metal out of the wash basket ball and sand grains. Solidification of concrete should be used a scraper to remove. 7, after the job should go to both sides of the piston chamber cleaning position and greased. Various parts of the operation switch, adjust the handles, hand wheels, levers, cocks, etc. should be reset MP1000 Planetary Concrete Mixer equipment, the hydraulic system should be uninstalled.
|
|